DBATU SY E&TC syllabus

DBATU · Second Year B.Tech Electronics & Telecommunication Engineering · NEP 2020

Electronic Devices and Circuits

25AF1372PC302 · Semester III · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Bipolar Junction Transistor

    6 hours

    BJT construction, working and characteristics; the transistor as a switch; configurations, current gain and stability factor; biasing methods; single-stage and RC-coupled amplifiers; effect of bypass and coupling capacitors; frequency response of the CE amplifier.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • BJT characteristics in CE configuration
    • DC load line, Q-point and BJT biasing
    • RC-coupled CE amplifier and its frequency response
  2. Unit 2: Junction Field Effect Transistor and MOSFET

    6 hours

    JFET characteristics, pinch-off and drain saturation current, CS, CD and CG amplifiers and biasing; depletion and enhancement MOSFETs and CMOS; the MOSFET as amplifier and switch, biasing, small-signal models, single-stage amplifier and capacitances; CMOS inverter; FET, MOSFET and BJT compared.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • JFET characteristics and parameters
    • JFET amplifiers and biasing
    • Enhancement MOSFET: structure and characteristics
    • MOSFET small-signal equivalent circuit and parameters
    • MOSFET as a switch and the CMOS inverter
    • BJT versus MOSFET
  3. Unit 3: Power Amplifiers

    6 hours

    Classification of power amplifiers (A, B, AB, C, D); transformer-coupled class A; class B push-pull and complementary symmetry; efficiency, power output and dissipation.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Classification of power amplifiers
    • Transformer-coupled class A amplifier
    • Class B push-pull and complementary symmetry amplifiers
    • Efficiency and power dissipation of power amplifiers
  4. Unit 4: Feedback Amplifiers and Oscillators

    6 hours

    Negative feedback: voltage-series, voltage-shunt, current-series and current-shunt, and their effect on impedances and gain; positive feedback and the Barkhausen criterion; LC, FET RC phase-shift, Wien bridge, Hartley and Colpitts oscillators.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Feedback topologies and their effects
    • Voltage-series and current-series feedback amplifiers
    • Barkhausen criterion and types of oscillators
    • RC phase-shift oscillator
    • Wien bridge oscillator
    • Hartley and Colpitts oscillators
  5. Unit 5: Voltage Regulator and Switched Mode Power Supply

    6 hours

    Discrete series and shunt transistor regulators; three-terminal and variable IC regulators; SMPS block diagram and types.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Series and shunt transistor voltage regulators
    • Power supply block diagram and three-terminal regulators
    • Adjustable regulators: IC 317 and IC 337
    • SMPS: buck and boost converters
    • Linear versus switch-mode power supplies

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).