DBATU SY Electrical syllabus

DBATU · Second Year B.Tech Electrical Engineering · NEP 2020

Power System

25AF1293PC401 · Semester IV · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Electrical Power Generation

    6 hours

    Evolution and layout of a power system; energy sources; thermal, hydro and nuclear power plants with block diagrams; alternator exciters and excitation systems; major equipment in generating stations.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Structure of a power system
    • Thermal, hydro and nuclear power plants
    • Excitation systems of alternators
  2. Unit 2: Electrical Design of Overhead Transmission Lines

    6 hours

    Inductance and capacitance of single- and three-phase lines with symmetrical and unsymmetrical spacing; GMD and GMR; transposition, bundled conductors and the earth effect; skin, proximity and Ferranti effects; corona loss and its reduction.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Inductance of a single-phase line
    • GMR and GMD
    • Inductance of three-phase lines and transposition
    • Bundled conductors
    • Capacitance of three-phase lines
    • Effect of earth on capacitance
    • Skin and proximity effects
    • Corona and corona loss
  3. Unit 3: Mechanical Design of Transmission Lines

    6 hours

    Conductor materials, stranded copper and ACSR; insulators and supports; voltage distribution across a string and string efficiency; wind and ice loading; sag with equal and unequal supports.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Conductor materials: copper and ACSR
    • Types of overhead line insulators
    • String efficiency
    • Sag calculation for overhead lines
    • Effect of ice and wind loading
    • Sag with supports at unequal levels
  4. Unit 4: Performance of Transmission Lines

    6 hours

    Classification of lines; short single- and three-phase lines and the effect of power factor; medium lines; long-line analysis; generalised constants; regulation and transmission efficiency.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Classification of transmission lines
    • Performance of short lines
    • Nominal-T and nominal-pi models
    • Long transmission lines
    • ABCD constants
    • Efficiency and regulation of lines
    • Ferranti effect
  5. Unit 5: AC and DC Distribution

    6 hours

    Classification, requirements and design of distribution systems; AC distribution calculations, unbalanced three-phase and four-wire star loads, ground detectors; DC distributors and the three-wire DC system.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Classification and requirements of distribution systems
    • AC distribution calculations
    • Unbalanced three-phase four-wire loads
    • DC distributors and the three-wire DC system

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).