DBATU SY Electrical syllabus

DBATU · Second Year B.Tech Electrical Engineering · NEP 2020

Electrical and Electronics Measurements

25AF1293PC302 · Semester III · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Introduction; Analog Ammeters and Voltmeters

    7 hours

    Accuracy, tolerance, sensitivity and reproducibility; absolute, secondary and recording instruments; PMMC and moving-iron instruments: construction, torque equation, range extension, temperature effects and errors.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Classification of measuring instruments
    • Types of errors in measurement
    • PMMC instruments
    • Moving-iron instruments
    • Extending the range of ammeters and voltmeters
  2. Unit 2: Analog Wattmeters, Power Factor Meters and Energy Meters

    7 hours

    Electrodynamometer wattmeter and power factor meter; active and reactive power in single-phase and balanced three-phase loads; the single-phase induction energy meter, lag adjustment and errors; maximum demand indicators.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Dynamometer wattmeter
    • Electrodynamometer power factor meter
    • Two-wattmeter method
    • Reactive power measurement in three-phase circuits
    • Single-phase induction energy meter
    • Maximum demand indicators
  3. Unit 3: Electrical Bridges

    6 hours

    DC bridges: Wheatstone, Kelvin's and Kelvin's double bridge, the megger, earth resistance and loss-of-charge measurement; AC bridges: Maxwell's, De Sauty, Anderson, Schering and Wien for inductance and capacitance.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Wheatstone bridge
    • Kelvin's double bridge
    • Measuring high resistance: loss of charge and megger
    • Earth resistance measurement
    • AC bridge balance equation
    • Maxwell's bridges
    • Anderson, De Sauty and Wien bridges
    • Schering bridge
  4. Unit 4: Instrument Transformers and Transducers

    6 hours

    CTs and PTs: construction, ratio and phase-angle errors, testing and applications; thermistors, RTDs, thermocouples, LVDTs, strain gauges, piezoelectric transducers, shaft encoders, tachometers and Hall-effect sensors.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Current and potential transformers
    • Ratios and burden of instrument transformers
    • Thermocouples, thermistors and RTDs
    • LVDT and RVDT
    • Temperature, Hall-effect and piezoelectric sensors
    • Strain gauges, shaft encoders and tachometers
  5. Unit 5: Electronic Instruments and Smart Energy Meters

    6 hours

    Digital voltmeters; dual-trace and dual-beam CROs, Lissajous patterns; the DSO; wave and harmonic distortion analysers; LCR and Q-meters; digital energy meter design, its algorithm and automatic meter reading.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Digital voltmeter and frequency meter
    • Cathode ray oscilloscope and Lissajous patterns
    • Digital storage oscilloscope
    • Wave and harmonic distortion analysers
    • Q-meter and signal generator
    • Smart energy meters and automatic meter reading

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).