DBATU SY Electrical syllabus

DBATU · Second Year B.Tech Electrical Engineering · NEP 2020

Analog and Digital Electronics

25AF1293PC403 · Semester IV · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Transistor as an Amplifier

    7 hours

    Load line; small-signal low-frequency analysis of single-stage amplifiers; the hybrid-pi model; cascaded and high-input-resistance amplifiers; frequency response, 3 dB bandwidth and the effect of cascading; classes of amplifiers.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Load line and transistor biasing
    • Small-signal analysis of single-stage amplifiers
    • Hybrid-pi model
    • Frequency response and 3 dB bandwidth
    • Cascaded amplifiers and classification of amplifiers
  2. Unit 2: Operational Amplifiers

    6 hours

    Block diagram and ideal op-amp; offset, bias, PSRR, CMRR and slew rate; internal circuit and current sources; frequency response; inverting and non-inverting operation; linear and non-linear applications.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Ideal op-amp and its parameters
    • Open-loop and closed-loop op-amp configurations
    • Frequency response of op-amps
    • Comparators and zero-crossing detectors
    • Instrumentation amplifier
  3. Unit 3: Number Systems and Boolean Algebra

    6 hours

    Binary, octal, decimal and hexadecimal numbers and conversions; BCD, Gray and excess-3 codes; 1's and 2's complement arithmetic; Boolean algebra and De Morgan's theorems; K-maps up to four variables in SOP and POS form.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Number systems and codes
    • Binary arithmetic with 1's and 2's complement
    • Boolean algebra
    • Karnaugh maps
    • SOP and POS reduction
  4. Unit 4: Logic Families

    6 hours

    TTL gate characteristics and the TTL NAND gate; open-collector and three-state outputs; TTL subfamilies; MOS and CMOS logic; gates in RTL, DTL and ECL; interfacing logic families.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • TTL NAND gate and its characteristics
    • Open-collector and tri-state outputs
    • MOS and CMOS logic
    • RTL, DTL and ECL
    • Interfacing logic families
  5. Unit 5: Combinational and Sequential Circuits

    6 hours

    Combinational versus sequential circuits; SR, clocked SR, D, JK and master–slave flip-flops; buffer, shift and controlled shift registers; ring, asynchronous, synchronous, up–down, twisted-ring and mod-N counters.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Introduction to sequential circuits
    • Latches and flip-flops
    • Shift registers
    • Ring and twisted-ring counters
    • Asynchronous counters
    • Synchronous counter design
    • Up-down and mod-N counters

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).