DBATU SY Civil syllabus

DBATU · Second Year B.Tech Civil Engineering · NEP 2020

Surveying

25AF1191PC303 · Semester III · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Linear Measurements

    6 hours

    Principles and classification of surveying; scales and conventional signs; ranging, chaining and offsetting; errors in chains and tapes and their corrections; setting perpendiculars, well-conditioned triangles; plotting chain survey data.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Principles and classification of surveying
    • Chain surveying: stations, lines and offsets
    • Tape corrections: length, slope, temperature, pull and sag
  2. Unit 2: Angular Measurements and Plane Table Survey

    7 hours

    Prismatic and surveyor's compasses; bearing systems and conversions; local attraction, declination and dip; compass traversing and adjustment of errors; plane table methods: radiation, intersection, resection and traversing.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Compass traversing and bearings
    • Local attraction and magnetic declination
    • Plane table surveying
  3. Unit 3: Levelling and Contouring

    7 hours

    Levels and staves; bench marks; temporary and permanent adjustments; fly and check levelling, booking and reduction; curvature, refraction and reciprocal levelling; longitudinal and cross sections; contouring; earthwork volumes and reservoir capacity; planimeters and areas and volumes.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Levels and levelling terms
    • Types of levelling
    • Reduced levels: collimation and rise-and-fall methods
    • Curvature, refraction and reciprocal levelling
    • Contours and contouring
    • Planimeter and the zero circle
    • Volumes by trapezoidal and prismoidal formulae
  4. Unit 4: Theodolite Traversing

    7 hours

    Vernier and micro-optic theodolites, their uses and adjustments; horizontal and vertical angles; heights and distances; theodolite traversing, closing error and its distribution; Gale's traverse table; omitted measurements.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Theodolite and its adjustments
    • Measuring horizontal and vertical angles
    • Latitudes and departures
    • Balancing a traverse
    • Omitted measurements
  5. Unit 5: Engineering Survey

    7 hours

    Reconnaissance, preliminary and location surveys; layout and setting out works; route surveys for highways, railways and waterways; mine surveying instruments; tunnels: correlating underground and surface surveys through shafts.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Reconnaissance, preliminary and location surveys
    • Setting out works and route surveys
    • Mine and tunnel surveying

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).