BAMU Final Year Mechanical syllabus

BAMU · Final Year B.E. Mechanical Engineering · CBCS (2019)

Tribology

MED458 · Elective II · Semester VIII · 4 credits · CT 20 + theory 80

One of the Elective II options.

All notes for this subject
  1. Unit 1: Introduction

    6 hours

    Tribology in design (oil seals and gaskets) and industry; modes of lubrication, lubricant properties and additives; sliding and rolling contact bearings.

    Examined in the 80-mark end-semester paper

    • Tribology and its importance
    • Lubricants and their properties
    • Rolling and fluid-film bearings
  2. Unit 2: Friction

    6 hours

    Laws, classes and causes of friction; adhesion, abrasion and junction growth theories; friction measurement; stick–slip.

    Examined in the 80-mark end-semester paper

    • Friction: laws and theories
    • Friction measurement and stick–slip
  3. Unit 3: Wear

    8 hours

    Classification of wear; wear between solids and between solid and liquid; factors and measurement; adhesive, abrasive, corrosive and fretting wear; friction control and wear prevention.

    Examined in the 80-mark end-semester paper

    • Wear: types and mechanisms
    • Wear testing methods
  4. Unit 4: Lubrication and Lubricants

    6 hours

    Boundary, mixed and full-film lubrication; hydrodynamic, hydrostatic and elastohydrodynamic lubrication; types and uses of lubricants, SAE grades, liquid and grease properties and selection.

    Examined in the 80-mark end-semester paper

    • Boundary and solid lubrication
    • Elastohydrodynamic lubrication
    • SAE grades and selection of lubricants
  5. Unit 5: Hydrodynamic Lubrication

    8 hours

    Pressure development in the oil film; 2D Reynolds' equation and side leakage; journal bearing design with the Sommerfeld number, Raimondi and Boyd and Petroff; design parameters, oil whip and whirl; hydrodynamic thrust bearings.

    Examined in the 80-mark end-semester paper

    • Mechanism of hydrodynamic lubrication
    • Reynolds' equation
    • Raimondi and Boyd charts and the Sommerfeld number
    • Petroff's equation
    • Hydrodynamic thrust bearings
  6. Unit 6: Hydrostatic Lubrication

    6 hours

    Principle of hydrostatic lubrication; bearing materials; hydrostatic step and pivoted pad bearings; hydrostatic lifts; squeeze films; optimum step bearing design.

    Examined in the 80-mark end-semester paper

    • Hydrostatic lubrication
    • Hydrostatic step bearing
    • Squeeze film lubrication

Unit contents are summarised from the official BAMU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Marathwada University (BAMU).