BAMU · Final Year B.E. Mechanical Engineering · CBCS (2019)
Automatic Control System
MED402 · Semester VII · 4 credits · CT 20 + theory 80
Unit 1: Introduction; Representation of Control System Components
8 hoursNeed for control; manual versus automatic, open- versus closed-loop systems; feedback and the generalised control system; transfer function; models of mechanical, electrical, thermal and fluid systems; force–voltage and force–current analogies.
Examined in the 80-mark end-semester paper
- Open- and closed-loop control systems
- Feedback and the generalised control system
- Transfer functions
- Mathematical models of mechanical and electrical systems
- Mathematical models of thermal and fluid systems
- Force–voltage and force–current analogies
Unit 2: Block Diagrams and Signal Flow Graphs
6 hoursBlock representation of system elements; block diagram reduction; converting between block diagrams and signal flow graphs; Mason's gain formula; transfer functions by both methods.
Examined in the 80-mark end-semester paper
- Block diagram reduction
- Signal flow graphs and Mason's gain formula
Unit 3: Control Actions and Controllers; Electrical Systems
6 hoursOn-off, P, I and D actions and their combinations (PI, PD, PID); pneumatic and hydraulic controllers compared; AC and DC servomotors, stepper motors, servomechanisms and position control.
Examined in the 80-mark end-semester paper
- On-off, proportional, integral and derivative control
- PI, PD and PID controllers
- Pneumatic and hydraulic controllers
- Servomotors, stepper motors and position control
Unit 4: Transient and Steady-State Response
8 hoursStandard input signals; first-order response to step, ramp and impulse; second-order step response and specifications; time constant; effect of damping ratio.
Examined in the 80-mark end-semester paper
- Standard test signals
- First-order system response
- Second-order system response and time-domain specifications
Unit 5: Frequency Response and Stability
8 hoursSystem stability and Routh's criterion; relative stability; Nyquist criterion and polar plots; gain and phase margins; Bode plots and stability from them.
Examined in the 80-mark end-semester paper
- Routh's stability criterion
- Polar plots and the Nyquist criterion
- Bode plots, gain and phase margins
Unit 6: Root Locus Plots
4 hoursRoot loci and the rules for constructing them; analysis with root locus plots; MATLAB in control systems.
Examined in the 80-mark end-semester paper
- Root locus
- MATLAB for control systems
Unit contents are summarised from the official BAMU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Marathwada University (BAMU).