BAMU · Final Year B.E. Electronics & Telecommunication Engineering · CBCS (2019)
VLSI Design
ETC404 · Semester VII · 4 credits · CT 20 + theory 80
Unit 1: Introduction to VHDL and Design of Digital Circuits
8 hoursMoore's law and the VLSI design flow; behavioural, dataflow and structural modelling, packages and configurations, functions, procedures and test benches; CPLDs and FPGAs.
Examined in the 80-mark end-semester paper
- Moore's law and the VLSI design flow
- VHDL entity and architecture
- VHDL modelling styles: behavioural, dataflow and structural
- Packages, subprograms and attributes
- VHDL test benches
- CPLD architecture
- FPGA architecture
Unit 2: Fault Tolerance and Testability
6 hoursStuck-open, stuck-short and stuck-at faults and fault coverage; design for testability, controllability and observability; boundary scan, JTAG and the TAP controller; full and partial scan paths.
Examined in the 80-mark end-semester paper
- Fault models
- Design for testability
- JTAG boundary scan and TAP controller
- Scan paths: full and partial scan
Unit 3: Introduction to CMOS
6 hoursMOS technology and the CMOS inverter, I–V and C–V characteristics of NMOS and PMOS, MOS gate and diffusion capacitance models, the voltage transfer curve, static and dynamic dissipation, noise margin and the beta ratio.
Examined in the 80-mark end-semester paper
- CMOS inverter characteristics
- MOS capacitance models and C–V characteristics
- Power dissipation and power-delay product
- Noise margins and the beta ratio
Unit 4: Non-ideal I–V Effects
6 hoursVelocity saturation and mobility degradation, channel-length modulation, body effect, threshold-voltage effects, sub-threshold conduction, junction leakage, tunnelling and the power–delay product.
Examined in the 80-mark end-semester paper
- MOSFET second-order effects
- Technology scaling
- Power dissipation and power-delay product
Unit 5: CMOS Design
6 hoursStatic and dynamic CMOS logic families, ratioed circuits, CMOS gates, pass-transistor logic and CPL, combinational and compound gates, and design with transmission gates.
Examined in the 80-mark end-semester paper
- CMOS combinational logic design
- Pass-transistor and dynamic CMOS logic: domino and zipper
- Latch-up and transmission gates
Unit 6: Fabrication and Layout
8 hoursN-well, P-well and twin-tub CMOS technology, the layout of a CMOS inverter, layout and design rules, wires and vias, and stick diagrams.
Examined in the 80-mark end-semester paper
- CMOS fabrication: photolithography, diffusion, ion implantation and the twin-tub process
- Lambda design rules and DRC
- Stick diagrams and cell layout
Unit contents are summarised from the official BAMU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Marathwada University (BAMU).