BAMU Final Year E&TC syllabus

BAMU · Final Year B.E. Electronics & Telecommunication Engineering · CBCS (2019)

Microwave and Radar Engineering

ETC402 · Semester VII · 4 credits · CT 20 + theory 80

Microwave engineering (Units 1–3) and radar (Units 4–6) are taught together here; the notes subject is Radar Engineering, which also carries the microwave topics.

  1. Unit 1: Microwave Transmission Lines and Components

    8 hours

    Microwave bands; waveguides compared with transmission lines, TE and TM propagation in rectangular waveguides, cut-off frequency and characteristic impedance, circular waveguides and planar lines, S-parameters; directional couplers, power dividers, tees, attenuators, resonators, isolators and circulators with their S-matrices.

    Examined in the 80-mark end-semester paper

    • Microwave frequency bands and applications
    • Rectangular waveguides and modes
    • Cut-off frequency and dominant mode
    • Circular waveguides
    • Scattering parameters
    • Directional couplers
    • Isolators and circulators
    • S-matrices of tees, couplers, isolators and circulators
  2. Unit 2: Active Microwave Semiconductor Devices and Tubes

    8 hours

    Gunn, tunnel, IMPATT and varactor diodes and parametric amplifiers; two- and multi-cavity and reflex klystrons, the travelling-wave tube and the magnetron.

    Examined in the 80-mark end-semester paper

    • Gunn diode
    • Tunnel diode amplifiers and oscillators
    • IMPATT and TRAPATT diodes
    • Varactor diodes and parametric amplifiers
    • Velocity modulation and klystrons
    • Reflex klystron
    • Helix travelling wave tube
    • Cavity magnetron
  3. Unit 3: Modern Trends in Microwave Engineering

    4 hours

    Effects of microwaves on the human body, medical and civil applications, EMI/EMC, MMIC fabrication, RF MEMS components and microwave imaging.

    Examined in the 80-mark end-semester paper

    • Microwave radiation hazards
    • Industrial and medical microwave applications
    • EMI/EMC, MMIC and RF MEMS
    • Radar tomography and microwave imaging
  4. Unit 4: Fundamentals of Radar

    8 hours

    The radar block diagram and range equation, frequencies and applications; detection in noise, probability of detection and false alarm, pulse integration, radar cross-section and its fluctuations, PRF and range ambiguities, losses, noise figure, mixers, duplexers, A-scope and PPI displays and matched filters.

    Examined in the 80-mark end-semester paper

    • Radar block diagram, frequencies and applications
    • Radar range equation
    • Probability of detection and false alarm
    • Integration of pulses, PRF and range ambiguities
    • Radar cross-section
    • Duplexers, mixers and radar displays
    • Matched filter detection
  5. Unit 5: MTI and Pulse Doppler Radar

    8 hours

    Doppler and MTI radar, delay-line cancellers, the MTI improvement factor, staggered PRFs, Doppler filter banks, MTI processing and its limits, AMTI, pulse Doppler radar, sub-clutter visibility and non-coherent MTI.

    Examined in the 80-mark end-semester paper

    • MTI radar and delay-line cancellers
    • Clutter and the MTI improvement factor
    • Staggered PRFs and Doppler filter banks
    • Pulsed Doppler radar
  6. Unit 6: Antenna Scanning and Tracking

    4 hours

    Monopulse tracking, conical scan and sequential lobing, low-angle tracking, phased and planar arrays and the limits of tracking accuracy.

    Examined in the 80-mark end-semester paper

    • Monopulse technique
    • Conical scan and sequential lobing
    • Tracking radar and angular resolution
    • Phased-array radar

Unit contents are summarised from the official BAMU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Marathwada University (BAMU).