BAMU Final Year E&TC syllabus

BAMU · Final Year B.E. Electronics & Telecommunication Engineering · CBCS (2019)

Advance Embedded System Design

ETC403 · Semester VII · 4 credits · CT 20 + theory 80

  1. Unit 1: Introduction to Embedded Systems

    4 hours

    Embedded systems defined and compared with general computing systems, their classification, life cycle and core, with examples such as a digital thermometer, navigation, software-defined radio and RF tags.

    Examined in the 80-mark end-semester paper

    • Embedded systems: classification and characteristics
    • Hardware–software co-design and the design life cycle
    • Microcontroller, microprocessor and SoC
  2. Unit 2: 32-bit RISC Processor: ARM7

    8 hours

    The ARM7 block diagram, big- and little-endian, operating modes, the programmer's model, the three-stage pipeline, barrel shifter, ARM and Thumb instruction sets, and ARM9/ARM11 features.

    Examined in the 80-mark end-semester paper

    • ARM7 architecture, operating modes and pipeline
    • ARM and Thumb instruction sets
    • ARM9 and ARM11 features
  3. Unit 3: Interfacing with Peripherals (LPC2148)

    8 hours

    ARM timers/counters and their registers, the watchdog timer, UART and I2C; interfacing a graphical LCD, SD card, ultrasonic sensor, accelerometer, stepper and servo motors.

    Examined in the 80-mark end-semester paper

    • LPC2148 timers, watchdog, UART and I2C
    • Interfacing GLCD, SD card and sensors with ARM
    • Sensor and actuator interfacing
  4. Unit 4: Cortex-M3 Microcontroller

    8 hours

    Cortex-M3 compared with ARM7, its block diagram, operating modes, bit banding, core registers, GPIO configuration and port bit set/reset registers.

    Examined in the 80-mark end-semester paper

    • ARM Cortex architecture overview
    • Cortex-M3 architecture and bit banding
    • Cortex-M3 GPIO configuration
  5. Unit 5: Programming with Cortex-M3

    4 hours

    The instruction set summary and embedded C programs for LEDs, temperature and pressure sensors, LCD, stepper, servo and DC motors, and the built-in ADC.

    Examined in the 80-mark end-semester paper

    • Embedded C on Cortex-M3: LEDs, sensors, motors and ADC
  6. Unit 6: RTOS-based Embedded System Design

    8 hours

    Operating-system basics, the need for and functions of an RTOS; non-preemptive and preemptive task scheduling; task communication through shared memory (pipes, memory-mapped objects) and message passing (queues, mailboxes, signals).

    Examined in the 80-mark end-semester paper

    • Real-time systems, tasks and threads
    • RTOS scheduling algorithms
    • Inter-task communication

Unit contents are summarised from the official BAMU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Marathwada University (BAMU).