QuizzesTCP Connection Lifecycle — Concept Check
advanced
computer-networks

TCP Connection Lifecycle — Concept Check

Questions on TCP Connection Lifecycle. The full TCP connection lifecycle — establishment (3-way handshake), data transfer with sequence numbers and acknowledgements, flow control, and graceful teardown (4-way FIN handshake) — underpins every reliable network communication.

8 minutes 8 questions Pass at 70%
Time Limit
8 minutes - timer starts when you begin
Change Answers Freely
Revisit and change any answer before submitting
Full Review After Submit
Correct answers and explanations shown for every question
Auto-submit on timeout
Quiz submits automatically when time runs out

Questions in this quiz

8 questions on TCP Connection Lifecycle — Concept Check. Work through them here, then start the quiz to answer them and see your score.

  1. 1.A server experiences slow connections and `netstat` shows many sockets in TIME_WAIT. What is likely happening?

    • AThe server's bandwidth is exhausted.
    • BThe server is under a DDoS attack.
    • CThe server's CPU is overloaded.
    • DThe server is handling many short-lived connections.
  2. 2.During a TCP connection teardown, a client sends a FIN and receives an ACK. What state does it enter next?

    • ACLOSED
    • BTIME_WAIT
    • CLAST_ACK
    • DFIN_WAIT_2
  3. 3.A TCP connection is established, but the server does not acknowledge data sent by the client. What might be the cause?

    • AThe server's IP address changed.
    • BThe server's sequence numbers are incorrect.
    • CThe server's receive window is full.
    • DThe server is in TIME_WAIT state.
  4. 4.A client sends a SYN, receives a SYN-ACK, but does not send an ACK back. What happens to the connection?

    • AThe connection is established.
    • BThe connection remains half-open.
    • CThe connection is closed immediately.
    • DThe connection is reset.
  5. 5.What is the purpose of the 3-way handshake in TCP?

    • ATo establish connection and exchange initial sequence numbers.
    • BTo synchronize clocks between client and server.
    • CTo close the connection gracefully.
    • DTo encrypt data before transmission.
  6. 6.A TCP connection is in ESTABLISHED state. What must happen before it can enter TIME_WAIT?

    • AThe client must send a FIN and receive a FIN-ACK.
    • BThe client must send a RST.
    • CThe server must send a FIN and receive an ACK.
    • DBoth client and server must send FIN and receive ACKs.
  7. 7.A TCP connection uses sequence numbers for reliable delivery. What happens if a segment is lost?

    • AThe receiver requests a new sequence number.
    • BThe receiver sends a duplicate ACK immediately.
    • CThe sender retransmits after a timeout.
    • DThe connection is reset.
  8. 8.A server shows many connections in FIN_WAIT_1. What does this indicate?

    • AThe server is experiencing packet loss.
    • BThe server is passively closing connections.
    • CThe server is actively closing many connections.
    • DThe server is establishing new connections.