QuizzesDead Letter Queues (DLQ) — Concept Check
intermediate
rabbitmq

Dead Letter Queues (DLQ) — Concept Check

Questions on Dead Letter Queues (DLQ). Messages that cannot be processed land in a DLQ; monitor DLQ depth as an SLA signal and build tooling to replay, inspect, or discard messages after investigation.

8 minutes 8 questions Pass at 70%
Time Limit
8 minutes - timer starts when you begin
Change Answers Freely
Revisit and change any answer before submitting
Full Review After Submit
Correct answers and explanations shown for every question
Auto-submit on timeout
Quiz submits automatically when time runs out

Questions in this quiz

8 questions on Dead Letter Queues (DLQ) — Concept Check. Work through them here, then start the quiz to answer them and see your score.

  1. 1.A service's DLQ depth is steadily increasing. What does this indicate?

    • AThe DLQ is empty.
    • BThe DLQ is not configured correctly.
    • CThe consumer is failing to process messages.
    • DThe messages are being processed too quickly.
  2. 2.You notice that messages are not being dead-lettered even though the queue is full. What might be missing?

    • Ax-overflow=reject-publish-dlx
    • Bx-dead-letter-exchange
    • Cx-dead-letter-routing-key
    • Dx-message-ttl
  3. 3.A message in RabbitMQ is dead-lettered due to expiration. What configuration could cause this?

    • Ax-dead-letter-exchange is missing.
    • Bx-overflow is set to reject-publish.
    • Cx-message-ttl is set too low.
    • DThe DLQ is full.
  4. 4.What happens when a message is rejected with basicNack and requeue set to false?

    • AIt is routed to the DLQ via the DLX.
    • BIt is re-queued for another attempt.
    • CThe message is permanently lost.
    • DIt is processed successfully.
  5. 5.In the DLQ configuration, what is the purpose of x-dead-letter-routing-key?

    • ASpecifies the DLQ name.
    • BOverrides the routing key for DLX.
    • CDetermines message priority.
    • DSets the TTL for messages.
  6. 6.A developer assumes a DLQ is automatically created in RabbitMQ. What is the reality?

    • ADLQs are created by default.
    • BDLQs must be manually configured.
    • CDLQs are only needed for expired messages.
    • DDLQs are optional for all queues.
  7. 7.Why might a message be re-queued instead of sent to the DLQ?

    • AThe DLX is missing.
    • BThe message is too large.
    • CThe DLQ is not configured.
    • DThe message is recoverable and requeue=true.
  8. 8.What is a critical SLA metric related to DLQs?

    • AQueue name
    • BMessage size
    • CDLQ depth
    • DRouting key