QuizzesAdvanced Graph Algorithms: Network Flow & Max-Flow Min-Cut Theorem Mastery
intermediate
dsa

Advanced Graph Algorithms: Network Flow & Max-Flow Min-Cut Theorem Mastery

Assess your understanding of advanced network flow algorithms and the Max-Flow Min-Cut Theorem.

18 minutes 12 questions Pass at 70%
Time Limit
18 minutes - timer starts when you begin
Change Answers Freely
Revisit and change any answer before submitting
Full Review After Submit
Correct answers and explanations shown for every question
Auto-submit on timeout
Quiz submits automatically when time runs out

Questions in this quiz

12 questions on Advanced Graph Algorithms: Network Flow & Max-Flow Min-Cut Theorem Mastery. Work through them here, then start the quiz to answer them and see your score.

  1. 1.Which algorithm is commonly used to find the maximum flow in a flow network?

    • AFord-Fulkerson Algorithm
    • BDijkstra's Algorithm
    • CKruskal's Algorithm
    • DPrim's Algorithm
  2. 2.In the context of network flow, what does the 'capacity' of an edge represent?

    • AThe shortest path length
    • BThe maximum flow rate allowed
    • CThe minimum cut required
    • DThe maximum number of nodes connected
  3. 3.What is the primary purpose of the Max-Flow Min-Cut Theorem?

    • ATo calculate the minimum spanning tree
    • BTo identify cycles in a graph
    • CTo determine the maximum flow and minimum cut in a network
    • DTo find the shortest path in a graph
  4. 4.Which data structure is typically used to represent a flow network?

    • AHash Table
    • BBinary Search Tree
    • CPriority Queue
    • DAdjacency List
  5. 5.What is an augmenting path in the context of the Ford-Fulkerson algorithm?

    • AA path that can increase flow
    • BA path that decreases flow
    • CA path that is part of the minimum cut
    • DA path that increases capacity
  6. 6.How does the Edmonds-Karp algorithm improve upon the basic Ford-Fulkerson method?

    • ABy using depth-first search
    • BBy using breadth-first search
    • CBy using dynamic programming
    • DBy using a greedy approach
  7. 7.What is the time complexity of the Edmonds-Karp algorithm for finding maximum flow?

    • AO(VE^2)
    • BO(V + E)
    • CO(V^2E)
    • DO(E log V)
  8. 8.In a flow network, what does a 'cut' refer to?

    • AA path from source to sink
    • BA cycle in the graph
    • CA subset of edges
    • DA partition of vertices
  9. 9.Which of the following is a characteristic of a residual graph?

    • AIt contains only backward edges
    • BIt shows possible additional flow
    • CIt contains only forward edges
    • DIt represents the minimum cut
  10. 10.What is the significance of a zero-capacity edge in a flow network?

    • AIt represents an infinite capacity
    • BIt is ignored in calculations
    • CIt cannot carry any flow
    • DIt indicates a bottleneck
  11. 11.In the context of network flow, what is a 'source'?

    • AA node with no outgoing edges
    • BA node where flow terminates
    • CA node where flow originates
    • DA node with no incoming edges
  12. 12.Which condition must be satisfied for a flow to be considered valid in a flow network?

    • AFlow exceeds capacity
    • BFlow is cyclic
    • CFlow is negative
    • DFlow conservation at each node